Sugar Sand Jet Boat Problems – 7 Issues and Solutions

sugar sand jet boat problems

Sugar sand jet boats are so popular because they are fun-to-ride machines. But as we all know, everything has some flaws in them. Sugar sand jet boats are no different, they have some problems in them as well.

But what are the sugar sand jet boat problems?

Extra noise, poor fuel consumption, and costly maintenance are some of the common problems.

But these aren’t enough problems. Poor battery backup, sucking objects while sailing, speed latency, etc. also adds up to the hassle.

However, amidst all these problems, there are a lot of pros to them also.

This brief portion may have some information gaps which can leave you bothered. But don’t worry; we’ve cleared out all the things as you proceed further. So, please have a read.

7 Common Sugar Sand Jet Problems

Jet Boats problems

You’ve had a glimpse of the problems that can occur in a sugar sand jet boat. Here we’ve discussed them in detail. We’ve divided them into 7 points so that you can get them easily. So, let’s proceed further.

Problem 1: Extra Loudness After A Certain Speed

Normally you don’t need any ear protection when you board the other boats. However, your opinion might change when you ride on a sugar sand jet boat.

The speed of jet boats can go up to 65 mph. The average speed of a jet boat is 25 mph. But looking at the boat speedometer operating, you can see sometimes it goes over 30 mph. And that’s when you hear excessive loud sounds.

The decibels of the sound is almost double and it’s very uncomfortable. So, it’s one of the problems of jet boats.

Problem 2: Sucks Different Objects in Shallow Water

Another problem with the sugar sand jet boat is that it sucks different objects in shallow water. For example, it tends to suck objects like seaweed, algae, rocks, etc.

This is problematic because it can damage the impeller and other components of the boat.

The solution to this problem is to turn off the engine upon reaching the shallow water. Then you can use the current waves and the boat speed to reach the beach.

And while taking off, ask someone to push your boat to get through the shallow water. Also, remember to wash away the sands and other objects if there are any.

Another fix is to use an outboard motor if it’s compatible with your jet boat. It’s also easier to clean the outboard motors. However, adjust the outboard well following proper instructions.

Jet Propulsion Boats

Problem 3: Poor Fuel Efficiency

If you’re fond of saving fuel, this boat might disappoint you. Sugar sand jet boats operate at high RPM. This is a potential reason that causes them to consume more fuel.

However, high RPM is not the only reason. Because there are boats that operate at high RPM and still give a decent fuel economy. However, Sugar sand jet boats just tend to give lower fuel efficiency compared to other boats.

Problem 4: High Maintenance Cost

Sugar sand jet boats are not only expensive but maintaining them is costly as well. These jet boats have very sophisticated engines and taking care of them costs you more. They also need expert supervision for maintenance.

The routine maintenance and tuning up your boat engine costs a lot of money. So, you can find it problematic to maintain a sugar sand jet boat.

Problem 5: Bilge Pump And Low Battery Capacity

Sugar sand jet boats have bilge pump functions that may not deliver satisfactory power according to demand. The battery backup isn’t also praiseworthy.

The jet boats do move very fast and can take sharp turns. But these two issues affect the whole system. It’s not something that’s expected and it’s problematic.

Problem 6: Not Enough Torque

Some models of sugar sand jet boats have low torque. Due to lack of torque, it becomes hard to keep up the pace.

While operating at high RPM, more torque is needed to accelerate the boat. But the low torque makes it hard to do so. You can notice this problem by looking at the tachometer of your boat when the RPM increases.

Problem 7: Speed Latency

Sugar sand jet boats can be run at both high speed and low speed. However, you can notice speed latency in these boats. The boat hesitates to kick in at a higher speed when operated at low speeds for long.

The opposite can happen as well. That means it will take time to slow down if it’s been at high speed for longer. So, this is an issue worth mentioning.

So, these were the 7 common problems that you face in sugar sand jet boats.

Some Advantages of Jet Boats

Jet Boats advantages

We’ve already discussed the problems with jet boats. However, those problems aren’t the only thing that defines jet boats. So, here we’re listing some of the advantages that you get from owning a jet boat.

Jet boats offer a great top speed. Also, they deliver tremendous power and propulsion. However, this output can vary depending on your motor setup and driving skill.

Jet boats do not have any exterior propellers which makes them a safe option. You won’t have to worry about the disadvantages of exterior propellers. Especially, if you have small kids in your household, this feature can be greatly helpful.

The interior is more utilized in a jet boat. So, you get considerably more space which is a great advantage. You can place your various equipment conveniently.

As there’s no exterior propeller in jet boats, you can do wake surfing. This is a great advantage for you if you’re a watersport fan.

So, these were some of the good things that jet boats offer.


What’s the cost of winterizing jet boats?

If you winterize your jet boat yourself, it can cost around $250. And this cost is inclusive of all the things you’ll need to do.

However, if you winterize your boat from outside the boat yards, it will cost more. In that case, the cost can be up to $500.

Is it possible to winterize a sugar sand jet boat?

Yes, you can do it in 4 steps. These are:

  1. Fill the tank and stabilize the fuel.
  2. Flush all the water from the engine.
  3. Fog and lubricate the engine.
  4. Remove the batteries.

What’s the performance of jet boats in rough water?

Jet boats are not made for operating in rough water. So, their performance is horrible in rough water. Riding a jet boat in rough waters can be a nightmare.

Is it OK to start a jet boat out of water?

If you are starting a jet boat out of water, there are a few things you need to keep in mind. First, make sure that the area around the boat is clear of any obstacles.

Second, be sure to have the proper safety equipment on board, including life jackets and flares. Finally, make sure that you have enough fuel on board to get to your destination.

Who makes sugar sand jet boats?

Sugar Sand jet boats are manufactured by Sugar Sand Marine Industries Inc., a Canadian company based in Quebec.


We tried to let you hover around all the sugar sand jet boat problems. Hope our article was effective enough to satisfy you.

Despite the problems, jet boats are of great utility.

However, you should use it for the right cause. Or else, you’ll feel it’s a waste of time and money.

That’s all we had to say. Have a good time with your jet boat!

Related Articles